+3 Magazine Extension for Canik METE 15 and 18 Round Magazines

Canik METE +3 Magazine Extension

You've asked and now we're answering. Introducing our newest +3 magazine extension for the METE Series 15 and 18 round magazines. Made from carbon fiber reinforced nylon, this economical mag extension is no slouch in the engineering department, with the material being one and half times stronger than aluminum. Takes your 15 round mag to 18 rounds and your 18 round mag to 21 rounds. Get yours today!

Magazine not included.

*** A 20% restocking fee may be applied on returned magazine extensions that have been installed and are damaged. Non-installed parts will receive a full refund (minus shipping). ***

Listing is for 1 +3 Round Magazine Extension.

Fits Canik METE MC9, METE SFT, METE SF, METE SFT PRO, METE SFX, and METE SFX PRO 15 round and 18 round Magazines. *** Will NOT fit 12 round or 20 round Magazines. ***

As always, proudly made right here in the USA.

Installation: Remove the factory base pad by inserting a punch/flat head screw driver into the rectangular hole in the base to push the spring pad and mag spring up to allow the base pad to slide forward and off the mag tube. Make sure to place your thumb under the mag tube while removing the base pad so the spring pad and spring don't go shooting off. Remove the two phillip screws from the new extension to separate the two pieces. While holding the spring and spring pad up in the mag tube, place either the left or right side of the extension in place with the mag shoulder inserted in the inside channel of the extension. While holding the mag tube and the installed side of the extension in place, remove your thumb holding the mag spring and spring pad. They should stay in place resting on the held installed side. Align the opposite side of the extension with the installed side making sure the mag tube shoulder on that side is in that sides channel. Hold both sides together with one hand while reinserting the phillip screws and snug them up, Blue Loctite can be used on the screws. Please make sure the spring pad is seated correctly in the rectangular hole in the base of the new extension, If it is not you can use a punch to move that plate around or tap the mag on the side to seat the spring pad.