Optic Mount Plate for Beretta Nano Pistols

Nano Optic Mounting Plate

We present to you the Optic Mount Plate for the Beretta Nano Pistols. This Optic Mount is for the Micro Optics line. Made from aircraft grade aluminum and then hard anodized to mil spec for longevity and scratch resistance. This is the optic mount that you need to bring your Nano to the next level. No gunsmithing required to mount this plate. No milling of the slide required.

Please refer to the approved Optics List below for the 28 optics we know fit our plate.

Get yours today!

Listing is for one Optic Mount Plate, (2) 6-32 x 5/16 Hex Flat Head Cap Screws, (2) 6-32 x 3/8 Hex Button Head Cap Screws,  and one 8/32 Set Screw. *** Optic NOT included ***

*** For the installation of your optic, Blue Locktite is required. Do not use the metric screws that came with your optic, we provide both Button Head Cap screws and Flat Head Cap screws in the correct thread size for our Optic Mount Plate to mount your optic to our plate. Screw head type selection is determined by the type needed for your particular optic. The 8/32 set screw is to be used to secure the Optic Plate to your slide. Holes for mounting the optic are tapped for 6/32 screws. ***

Available in Black. 

Fits Beretta Nano Pistols. *** Will NOT fit the APX A1 Carry Single Stack and APX Carry Single Stack. ***

As always, proudly made right here in the USA.

Micro Optics Fit List

These Micro Optics are approved for use on our optic mount plate.

***The Holosun 407k and 507k can vary in the location stud height due to the different production runs. The pegs are correct for the optics listed but there can be some differences in those optics from what we have found over the last year or so. Sanding the locating studs down is the option to allow them to fit in that case.***

We strive to make all parts we manufacture to be drop in, although there is the rare occasion where a part will HAVE to be fitted to the tolerances of your particular pistol. We cannot control the tolerances of mass produced firearms, therefore we highly suggest that if you run into a tolerance issue to contact us at tech@gallowayprecision.com before taking it to a qualified armorer to fit the part. We also offer installation of all triggers, trigger kits, and parts that we make for a nominal fee.