+1 Magazine Extension for Smith & Wesson M&P 10mm M2.0 Pistols

M&P 10mm M2.0 +1 Magazine Extension

You've asked and now we're answering. Introducing our newest +1 magazine extension for the M&P 10mm M2.0 15 round factory magazines. Made from carbon fiber reinforced nylon, this economical mag extension is no slouch in the engineering department, with the material being one and half times stronger than aluminum. Not only does the extension add an extra round making the mag a 16 round capacity. Get yours today!

Installation: Remove the factory base pad from the mag tube. Our extension includes a cap on the front top and cap head screw from the bottom front for retention. Remove the cap head screw and cap to allow clearance for the mag tube and shoulders. Replace the floor plate under the mag spring and while holding the new floor plate and spring up in the mag tube, slide the extension from the front of the extension on the rear of the mag tube to install the extension. Replace the cap on the front top of the extension and then turn the cap head screw clockwise from underneath until the cap is secure (no need to over-tighten, just snug it up). This will block the mag tube to keep the extension from sliding backward. Use a 3/32 allen wrench to make the adjustments.

Magazine not included.

*** Need of an 3/32 Allen Wrench? Please select it from the drop-down before adding the Extension to the cart. If you are ordering more than 1 Extension and need only 1 Allen Wrench please add 1 with an "3/32 Allen Wrench" to the cart and then click the "Continue shopping" button to return to the listing and select "No Allen Wrench" and add the additional quantity of Mag Extensions needed to the cart. Tools are non-refundable. ***

Fits Smith & Wesson M&P 10mm M2.0 15 Round Factory Magazines.

As always, proudly made right here in the USA.

*** A 20% restocking fee will be applied on returned magazine extensions that have been installed. Non-installed parts will receive a full refund (minus shipping). ***