+3 Magazine Extension for Taurus TS9 Pistols

+3 Magazine Extension for Taurus TS9 Pistol

You've asked and now we're answering. Introducing our +3 Magazine Extension for the TS9 pistol. Made from carbon fiber reinforced nylon, this economical mag extension is no slouch in the engineering department, with the material being one and half times stronger than aluminum. The extension adds three rounds making your mag a 20 round magazine now. Get yours today!

Includes a cap and cap head screw on the top front for retention. Back the cap head screw out to remove the cap and clear the channels in the extension for the mag tube shoulders. Remove the factory base pad from the mag tube by pushing upward from the bottom on the button extrusion of the spring pad coming through the bottom of the base pad and slide the factory base pad forward off the mag tube. Be sure to hold your thumb under the spring pad to keep the pad and spring in place and from shooting off. Install the mag extension by sliding it on the mag tube from the back of the tube until fully seated, then replace the cap and turn the cap head screw clockwise until it is snugged up, this will to keep the extension from sliding backward on the tube. There is no need to over-tighten the set screw,it is only used to block the mag tube from sliding backward. Use a 3/32nd allen wrench to make the adjustments.

*** Need of an 3/32nd Allen Wrench? Please select it from the drop-down before adding the Extension to the cart. If you are ordering more than 1 Extension and need only 1 Allen Wrench please add 1 with an "3/32nd Allen Wrench" to the cart and then click the "Continue shopping" button to return to the listing and select "No Allen Wrench" and add the additional quantity of Mag Extensions needed to the cart. Tools are non-refundable. ***

Listing is for one +3 Magazine Extension. Magazine is Not included.

Fits Taurus TS9 Factory Magazines Only.

As always, proudly made right here in the USA.