+1 Magazine Extension for Canik TP9 Elite SC 12 Round Magazines

Canik Elite SC 12 Round Mag +1 Magazine Extension

You've asked and now we're answering. Introducing our newest +1 magazine extension for the TP9 Elite SC 12 round magazines. Made from carbon fiber reinforced nylon, this economical mag extension is no slouch in the engineering department, with the material being one and half times stronger than aluminum. Get yours today!

Magazine not included.

*** Need of an .050 Allen Wrench? Please select it from the drop-down before adding the Extension to the cart. If you are ordering more than 1 Extension and need only 1 Allen Wrench please add 1 with an ".050 Allen Wrench" to the cart and then click the "Continue shopping" button to return to the listing and select "No Allen Wrench" and add the additional quantity of Mag Extensions needed to the cart. Tools are non-refundable. ***

Listing is for 1 +1 Round Magazine Extension.

Fits Canik TP9 Elite SC 12 Round Magazines. *** Will NOT fit 15 Round Magazines. ***

As always, proudly made right here in the USA.

*** A 20% restocking fee may be applied on returned magazine extensions that have been installed and are damaged. Non-installed parts will receive a full refund (minus shipping). ***

Installation: We recommend the use of Blue Loctite on both set screws in the extension. Please double check when reinserting the set screws that the two set screws allow enough clearance for the mag shoulders to slide unimpeded into the channels of the extension. Remove the factory base pad by inserting a punch into the rectangular hole in the base to push the spring pad and mag spring up to allow the base pad to slide forward and off the mag tube. Make sure to place your thumb under the mag tube while removing the base pad so the spring pad and spring don't go shooting off. While holding the spring and spring pad up in the mag tube, slide the extension in place from the front of the mag tube until fully seated. Turn the set screws clockwise until they block the mag shoulders channels and keep the extension from sliding forward on the mag tube. Please make sure the spring pad is seated correctly in the rectangular hole in the base of the new extension, If it is not you can use a punch to move that plate around or tap the mag on the side to seat the spring pad.