Arminius Short Stroke Trigger and Safety Delete for SAR USA SAR9 Full Size Pistols

Arminius Short Stroke Trigger and Safety Delete for the SAR9 Full Size Pistol

We are very pleased to present our newest trigger addition, the Galloway Precision Arminius for the SAR USA SAR9 Full Size pistols. Arminius was a Germanic tribal chief who commanded the Germanic tribes in battle against the Roman Empire at the Battle of the Teutoburg Forest in 9 AD. He and the tribes at his command, in a very brutal and bloody battle, destroyed 3 Roman Legions and the auxiliaries attached to them.

It is in that same vein that we designed the Arminius. Our trigger reduces travel by up to 25% (depending on the tolerances of your particular pistol) with a built in pre and post travel stop. Made from 3D printed carbon fiber filled ballistic nylon, this trigger is made to last and is the lightest physical weight trigger on the market for the SAR9. It's flat face design gives the shooter more room for the pad of the trigger finger, and the changed swing geometry will provide comfortable shooting for hours of training or plinking. Become one with your gun and get your Arminius today!

Now comes with our new Safety Delete. This conversion pin is a drop in replacement for the factory SAR9 full size safety lever. It will convert the pistol to just a trigger safety blade like the new SAR9c version. Knock out the 2mm pin remove the removable lever and pull the safety lever out, then install the new pin as shown in the pictures. 

Now available with a Black Safety Blade (Carbon Fiber Reinforced Nylon) or a Red Safety Blade (Glass Fiber Reinforced Nylon).  

Safety Delete comes in Black Stainless Steel or Stainless Steel. Black Stainless is currently out being Blacked and will be available some time in the next few weeks.

*** Both the Arminius Trigger and Safety Delete must be used for proper function. ***

Fits the SAR USA Full Size SAR9 Pistols. *** Does not fit the SAR9 X Pistol. The reset bar has changed on the X models. ***

As always, proudly made right here in the USA.

We strive to make all parts we manufacture to be drop in, although there is the rare occasion where a part will HAVE to be fitted to the tolerances of your particular pistol. We cannot control the tolerances of mass produced firearms, therefore we highly suggest that if you run into a tolerance issue to contact us at tech@gallowayprecision.com before taking it to a qualified armorer to fit the part. We also offer installation of all triggers, trigger kits, and parts that we make for a nominal fee.